familyname=Stationary Decoder
manufacturer=Team Digital, LLC
definitionSource=JMRI
CV=1,"Servo Address"
CV=2,"On Time CV value"
CV=3,"Servo 1 Move Range"
CV=5,"Relay Address"
CV=7,","None","","Restart the Servette","","Move servos to center position","","Move servos back and forth","","Move servos to one end","","Move servos to the other end",""Test State"
CV=7,"Version ID"
CV=8,"Manufacturer ID"
CV=10,"Servo 1 Center Position"
CV=11,"Servo 2 Center Position"
CV=12,"Route 1 Address"
CV=14,"Route 2 Address"
CV=16,"Route 3 Address"
CV=18,"Route 4 Address"
CV=20,"Route 5 Address"
CV=22,"Route 6 Address"
CV=24,"Route 7 Address"
CV=26,"Route 8 Address"
CV=29,","Mode 1 - Servo 2 Pos, output 2 has unique address","","Mode 2 - Servo 2 Pos, output 2 has servo address","","Mode 3 - Servo 3 Pos, output 2 has unique address","","Not used -do not select","","Mode 4 - Inputs control servo, output 2 has unique address",""Mode"
CV=29,"Option 1"
CV=29,"Option 2"
CV=29,"Option 3"
CV=31,"Ops Mode Address"
CV=33,","b","3","t","1","c","2""
CV=34,","t","1","c","2""
CV=36,","Input Disabled","","On Low to High Transition","","On High to Low Transition","","On Change Transition",""Transition"
CV=36,"Output Number"
CV=36,","Close","0","Throw","2","Toggle","1"   Output State"
CV=44,","Input Disabled","","On Low to High Transition","","On High to Low Transition","","On Change Transition",""Transition"
CV=44,"Output Number"
CV=44,","Close","0","Throw","2","Toggle","1"   Output State"
CV=67,"Servo Move Speed"
CV=71,","None","0","Sequence or rotate","1","Speed to Position","2"Servo Behavior"
CV=71,"Reverse"
CV=75,","None","","Will flash when servo is in the cw position","","Will flash when servo is in the ccw position",""Relay"
Basic------  Servette Output Addresses  ------ Use this number to set the address numberof the device the output is connected to.------  Special Functions  ------ This is the same as a Loco address------  Notes:  ------ The Custom Programmer format is recommendedMfg---- Sets the Servette to a particular test state - Use to help adjust servos ----            Only works in Ops mode            Changes the value of CV7 (Version ID) as displayed in DP            Test State may change when Version ID is readInputs------  Primary Input Control 1  ------ ------  Secondary Input Control 1  ------ Outputs---- Servo Configuration -------- Output Flashing -------- Sets the output state to always be the same at power on ----              Only applies if Option 1 is selectedServette   Both  Throw  CloseRelay  Throw  CloseRoutes---- Remote Control Route Address ----CVs