familyname=Series 7 Boards
manufacturer=Digitrax
definitionSource=JMRI
LOCONETBD7OPSWMODECV=1,"Base Address"
CV=7,"Device Type"
CV=8,"Device Manufacturer (NMRA number) "
CV=9,"Serial Number"
CV=11,","","0Pulsed (Solenoid)","","1Slow Motion (Constantly-powered)"Switch Outputs Type is"
CV=11,","","Switch Command Mode","","DCC Aspect Signal Control Mode"Signal Control Mode is"
CV=11,","","enabled","","disabled"Internal Routes are"
CV=12,","","disabled","","enabled"Bushby Bit is"
CV=12,","","do turnout, sensor commands","","trigger routes"Input Lines"
CV=12,","","Loconet switch commands","","DCC switch commands only"Command source is"
CV=12,","","echo to Loconet","","do not echo to Loconet"Route Switch Commands"
CV=12,"Turnout Typeeq0,"","normal","","high CD voltage"Solenoid Pulse"
CV=14,","","normal B0 (<OPC_SW_REQ>) format messages","","special B2 (<OPC_INPUT_REP>) format messages"For switch messages, send"
CV=15,","","0separate Red/Yellow/Green outputs","","1separate Red/Yellow/Green outputs (Alternate)","","23-wire "Searchlight" outputs","","32-wire "Searchlight" outputs"Signal lamps use"
CV=15,","","common anode","","common cathode"Signals wired with"
CV=15,","0","flashing yellow","1","dark","2","flashing red","3","flashing green"Fourth aspect is"
CV=15,","","enabled","","disabled"SW1021/2022 signal broadcast: "
CV=16,","","not persistent","","persistent"Lunar Aspects are"
CVs<html>The "CV" column in the table above shows CV
                        numbers, not the Op Switch number.<p>To see those, hover
                        your mouse over a variable on the OpSw Settings pane.
                        <p>CVs 1 and 2 are the low and high (respectively) 8-bit
                        "Base Address" values.<p>The "Base Address" is practically
                        limited to 2005, max. in "Switch" mode, <p>or 2032
                        max. when, in "Aspect" mode.<p>The "Roster" tool and its
                        Roster entries <em> cannot</em> change the
                        "Base Address".
                    Basic<html>
                <p>This roster entry will only access the specified
                board if the Base Address specified above <br>was
                correctly entered when the roster entry was first created.
                You <em>cannot</em> change it in the Roster Entry.
            </html>Signal OpSw Settings<html><span style="color: black;"><h2><strong>
                Signaling Mode</strong></h2></html><html><span style="color: black;"><h2><strong>Signal Control Configuration</strong></h2></html><html><span style="color: black;"><h2><strong>Signal Lamp Configuration</strong></h2></html>Sw. Ctrl, Inputs Settings<html><span style="color: black;"><h2><strong>
                Switch Control Configuration</strong></h2></html>Turnout Typeeq1<html><span style="color: black;"><h2><strong>
                Inputs Configuration</strong></h2></html>