familyname=Series 7 Boards
manufacturer=Digitrax
definitionSource=JMRI
LOCONETBD7OPSWMODECV=1,"Board Address"
CV=7,"Device Type"
CV=8,"Device Manufacturer (NMRA number) "
CV=9,"Serial Number"
CV=11,","","over-current","","auto-reverse"DS1 mode: "
CV=11,","","over-current","","auto-reverse"DS2 mode: "
CV=11,","","over-current","","auto-reverse"DS3 mode: "
CV=11,","","over-current","","auto-reverse"DS4 mode: "
CV=11,","0","normal","1","lower","2","higher"Trip current: "
CV=12,","","enabled","","disabled"Occupancy detection: "
CV=12,","","enabled","","disabled"Transponding detection: "
CV=13,","0","Standard","1","Slow","2","Fast","3","Fastest"Section 1 Occupancy Detection speed: "
CV=13,","0","Standard","1","Slow","2","Fast","3","Fastest"Section 2 Occupancy Detection speed: "
CV=13,","0","Standard","1","Slow","2","Fast","3","Fastest"Section 3 Occupancy Detection speed: "
CV=13,","0","Standard","1","Slow","2","Fast","3","Fastest"Section 4 Occupancy Detection speed: "
CV=14,","","normal","","increased"Sensitivity: "
CV=16,","","detection and Transponding","","relay state (like the PM4x)"LEDs show: "
CVs<html>The "CV" column in the table above shows CV
                        numbers, not the Op Switch number.<p>To see those, hover
                        your mouse over a variable on the OpSw Settings pane.
                        <p>CVs 1 and 2 are the low and high (respectively) 8-bit
                        "Base Address" values.<p>The "Base Address" is practically
                        limited to 2040, max.<p>The "Roster" tool and its
                        Roster entries <em> cannot</em> change the
                        "Base Address".
                    Basic<html>
                <p>This roster entry will only access the specified
                board if the Base Address specified above <br>was
                correctly entered when the roster entry was first created.
                You <em>cannot</em> change it in the Roster Entry.
            </html>OpSw Settings<html><h2>Section "Mode"<html><h2>Occupancy Detection<html><span style="color: green;"><em>The "Occupancy Detection Speed" settings, below, apply to
                    PM74 "July 1, <p>2024 (version Rev 7)" and later firmware. Previous firmware versions
                    do <p>not implement these OpSws.<html><h2>Transponding<html><h2>Outputs