familyname=Series 7 Boards
manufacturer=Digitrax
definitionSource=JMRI
LOCONETBD7OPSWMODECV=1,"Base Address"
CV=7,"Device Type"
CV=8,"Device Manufacturer (NMRA number) "
CV=9,"Serial Number"
CV=11,","","0pulse solenoid (4 outputs)","","1slow motion (4 outputs)","","5Light mode (8 outputs)"Output type: "
CV=11,","","enabled","","disabled"Internal Routes are"
CV=12,","","disabled","","enabled"Bushby Bit is"
CV=12,","","do turnout, sensor commands","","trigger routes"Input Lines"
CV=12,","","Loconet switch commands","","DCC switch commands only"Command source is"
CV=12,","","echo to Loconet","","do not echo to Loconet"Route Switch Commands"
CV=12,","","normal","","high CD voltage"Solenoid Pulse"
CV=14,","","Disabled","","Enabled"'Interrogate' causes reporting of switch positions: "
CV=16,","","Enabled","","Disabled"CP1 LED is "
CVs<html>The "CV" column in the table above shows CV
                        numbers, not the Op Switch number.<p>To see those, hover
                        your mouse over a variable on the OpSw Settings pane.
                        <p>CVs 1 and 2 are the low and high (respectively) 8-bit
                        "Base Address" values.<p>The "Base Address" is practically
                        limited to 2033, max.<p>The "Roster" tool and its
                        Roster entries <em> cannot</em> change the
                        "Base Address".
                    Basic<html>
                <p>This roster entry will only access the specified
                board if the Base Address specified above <br>was
                correctly entered when the roster entry was first created.
                You <em>cannot</em> change it in the Roster Entry.
            </html>OpSw Settings<html><span style="color: black;"><h2><strong>Output Controls Characteristics</strong></h2></html><html><span style="color: black;"><h2><strong>Control Source Characteristics</strong></h2></html><html><span style="color: black;"><h2><strong>Local Inputs Characteristics</strong></h2></html><html><span style="color: green;"><em>
                    The "Interrogate Switches" settings, below, apply to
                    DS74 "April 7, 2022, <p> (version 0.4)" and later firmware. Previous firmware versions
                    do <p>not implement these OpSws.<html><span style="color: green;"><em>
                    The "Interrogate Switches" settings, below, apply to
                    DS74 "December 13, 2022, <p> (version 0.6)" and later firmware. Previous firmware versions
                    do <p>not implement these OpSws.<html><span style="color: black;"><h2><strong>Local Routes Characteristics</strong></h2></html>